Installation of the magnetic filter RBM MG1

The installation of MG1 is done on the heating return.

You can install the Magnetic filter in 3 different positions: vertical, horizontal or square position.

If you can isolate the area of the installation of MG1, follow the procedure below.

If you can’t isolate the area of the installation of MG1, firstly empty your heating circuit before proceeding with the installation of MG1.

To install the MG1 :

• Stop your boiler
• Empty the installation area (Attention : many liters of dirty water are to evacuate in the sewage)
• Install the MG1 on the heating return in one of the 3 different positions listed in the notice.
• Check the correct installation of the MG1 and the good position of the O-rings
• Check that the valve MG1 is in the open position
• Put the water in the circuit and then evacuate
• Restart the boiler

Discover the presentation and the installation sheet of the magnetic filter MG1.

Find the magnetic filter RMB MG1 on our website with the reference: 110010.